Microjig MATCHFIT Setup Gauge

Microjig MATCHFIT Setup Gauge

ref: SG-133

Quickly set up your Dado Stop with pinpoint accuracy.

• Fast, accurate setups for blade kerf, dado stop, bit depth, and blade height.
• Record your blade’s actual kerf (including runout) by trimming it into the Setup Gauge. This serves as a template to set up your Dado Stop for a fast, precise dado cut. Best of all—there's no dado blade required.
• Blade kerf template for precise Dado Stop setup.
• Record blade/saw combination for future reference.
• 11/32” blade height gauge for cutting relief grooves on table saw.
• 3/8” depth gauge for setting dovetail router bit cutting depth.
• Setup dados in a fraction of the time: 1 - Cut a scrap piece of MDF to template on side of your kerf. Without moving the fence, clamp the Setup Gauge to a crosscut sled, contacting the cut piece. 2 - Set blade height to the center of the notch. Remove MDF piece and push Setup Gauge through the cut. 3 - The material trimmed out is an exact replica of the blade’s kerf, including runout.  The resulting gap is used to account for the kerf when setting Leg 2 of the Dado Stop.